Honda Fit Body Side Moulding Clip | South Mountain Supply 3006
✓ In stock
The South Mountain Supply 3006 is a nylon body side moulding clip for Honda Fit vehicles. This exterior clip snaps securely into the door panel to anchor body side moulding strips in place, maintaining a factory-clean appearance and protecting the door surface beneath the trim from moisture and debris.
Specifications
- Type: Body Side Moulding Clip
- Material: Nylon
- Color: Black
- Pack Sizes Available: 15, 30, 60, 90
Vehicle Fitment
- Honda Fit — verify OEM number against your existing clip to confirm year range compatibility
Cross-Reference Numbers
- Honda OEM: Verify OEM number against your existing clip before ordering
What does this clip do on the Honda Fit?
The 3006 clip locks the body side moulding strip to the door panel on Honda Fit vehicles. Its snap-fit design holds the trim firmly against the body, preventing rattling, edge lifting, and wind-driven water from reaching the door surface and causing rust beneath the moulding.
How do I confirm the 3006 is correct for my Fit?
South Mountain Supply offers two Honda Fit moulding clip styles — 3005 and 3006 — for different Fit generations. To identify the correct clip, compare the 3006 profile to your existing clip or check the OEM part number stamped on the clip you are replacing.
How do I install the 3006 on a Honda Fit?
Use a plastic trim removal tool to carefully pry the moulding strip away from the door. Extract any broken clip fragments from the moulding channels and door panel holes. Press the new 3006 clips into the moulding, align the strip with the door surface, and press firmly along the length of the moulding until each clip snaps fully into place.
What pack size should I order?
The 3006 is available in packs of 15, 30, 60, and 90. A pack of 15 covers a spot repair on one or two doors. For a complete four-door Fit moulding replacement, a pack of 30 provides full coverage with extras. Packs of 60 and 90 deliver the best value per clip for body shops and fleet applications.
Why is it important to replace a broken moulding clip promptly?
A broken clip leaves a gap between the moulding and the door panel, allowing water to pool behind the trim. Over time, this leads to rust on the door surface, adhesion failure if the moulding uses both clips and tape, and the moulding strip eventually falling off entirely. Replacing a broken clip promptly is a simple repair that prevents costly body damage later.