Toyota Windshield & Gas Filler Specialty Rivet 90269-05054 | 3/16" with Plastic Cap | 20626
✓ In stock
Large-diameter specialty rivet with plastic cap for Toyota windshield side moulding and gas filler cap attachment. The 3/16" aluminum shank and wide 9/16" flange provide the extra holding strength needed for larger moulding sections, while the included plastic cap covers the mandrel head for a clean, factory-finished appearance. Matches Toyota OEM 90269-05054.
Specifications
- Type: Specialty Blind Rivet with Plastic Cap
- Application: Windshield Side Moulding & Gas Filler Cap
- Material: Aluminum Rivet / Steel Mandrel
- Rivet Diameter: 3/16"
- Grip Range: 1/8"–5/16"
- Flange Diameter: 9/16"
- Includes: Plastic Cap
Vehicle Fitment
- Toyota — windshield side moulding and gas filler cap applications
Cross-Reference Numbers
- Toyota OEM: 90269-05054
- SMS Part#: 20626
What does the plastic cap do?
The plastic cap snaps over the set mandrel head after the rivet is installed, concealing the mandrel remnant and providing a clean, finished appearance on visible moulding fastening points. It also helps prevent water ingress through the mandrel hole on exterior applications like windshield and gas filler mouldings.
Why is a larger 3/16" rivet used for windshield moulding?
Windshield side mouldings and gas filler caps experience more vibration and stress than small interior trim clips. The 3/16" diameter shank and wide 9/16" flange provide greater shear strength and pull-through resistance than a standard 1/8" rivet, keeping larger moulding sections secure over time.
Is this an OEM equivalent replacement?
Yes. This rivet matches Toyota OEM part number 90269-05054 and is a direct replacement for the factory-installed fastener in Toyota windshield side moulding and gas filler cap applications.
How do I install this rivet?
Insert the rivet shank into the panel hole, position the moulding, and use a standard rivet gun to set the rivet by pulling the mandrel until it breaks. Snap the plastic cap over the exposed mandrel remnant for a finished appearance. Use a 13/64" drill bit to clean up or create the pilot hole if needed.
What pack sizes are available?
Available in packs of 25, 50, 100, and 150 to suit single-vehicle moulding repairs or shop stock needs.