Toyota Windshield & Exterior Moulding Rivet 90269-04053 | 1/8" Long Grip with Cap | 20628
✓ In stock
Aluminum specialty rivet with plastic cap for Toyota windshield and exterior moulding applications requiring a longer grip range. The 5/32"–5/16" grip accommodates thicker panel stacks than the short-grip version (20627), while the included plastic cap conceals the mandrel head for a clean, factory appearance. Matches Toyota OEM 90269-04053.
Specifications
- Type: Specialty Blind Rivet with Plastic Cap (Long Grip)
- Application: Windshield & Exterior Moulding
- Material: Aluminum Rivet / Steel Mandrel
- Rivet Diameter: 1/8"
- Grip Range: 5/32"–5/16"
- Flange Diameter: 5/16"
- Includes: Plastic Cap
Vehicle Fitment
- Toyota — windshield and exterior moulding applications; verify OEM number against your existing rivet
Cross-Reference Numbers
- Toyota OEM: 90269-04053
- SMS Part#: 20628
What is the difference between 20628 and 20627 — they share the same OEM number?
Both 20628 and 20627 reference Toyota OEM 90269-04053, but they have different grip ranges: 20628 has a longer grip range of 5/32"–5/16" for thicker panel stacks, while 20627 has a shorter grip range of 3/64"–3/16" for thinner assemblies. Measure your total panel stack thickness to select the correct version.
When would I need this longer grip version instead of 20627?
Use 20628 when the combined thickness of your moulding and body panel exceeds 3/16" (the upper limit of the short-grip 20627). Applications with additional backing plates, foam weatherstrip, or thicker panel sections typically require the longer grip range found in 20628.
What does the plastic cap do?
The plastic cap snaps over the set mandrel remnant after installation, concealing it and providing a clean, finished appearance on exterior moulding fastening points. It also helps seal the mandrel hole against moisture ingress on windshield and exterior panel applications.
Is this an OEM equivalent replacement?
Yes. This rivet matches Toyota OEM part number 90269-04053 and is a direct replacement for the factory-installed fastener in Toyota windshield and exterior moulding applications requiring the 5/32"–5/16" grip range.
What pack sizes are available?
Available in packs of 25, 50, 100, and 150 to suit single-vehicle moulding repairs or shop stock needs.